IPX DDK-1500D - Manual (Page 14)

14
3.3 CONNECTING WITH A MULTIPLEXER
3.4 UPDATING SYSTEM SOFTWARE
If the system software of the IP CAMERA needs to be upgraded, please take the following steps
to safely process it.
Important: Before carrying out the following procedures, please ensure the SD card is
working and the file of the system firmware is intact
1. Format an SD card using the FAT16 format if it is unformatted; there are no limitations to an SD
card’s capacity.
2. Create a directory named IPCAM in the SD card if it does not exist.
3. Copy the file of UPDATE.BIN to the IPCAM -directory.
4. If the IPCAM is running, please power it off first.
5. Insert the SD CARD into the IPCAM.
6. Remove the Ethernet cable from the RJ-45 port and then power on the IPCAM.
7. In 5 to 10 seconds, a message reading "UPDATE PROCESSING" will show up on the screen on
a blue background; if not, please check out steps 1 to 6 carefully or else inform your technical
support while ignoring the following steps.
8. DO NOT power off the IPCAM while this update process is running until the message "UPDATE
OK RESET PLEASE" appears on the screen; it might take 15 to 30 seconds to appear.
LAN CAME
LAN CAME
LAN CAME
TO LAN CAMERA VIDEO OUT BNC CONNECTOR
IP CAMERA 1
IP CAMERA 2
IP CAMERA16