Pump Solutions Group Neptune Polymaster - Manual (Page 7)

Polymaster ™ Accessories
Desiccant breather
mounts to 19 mm (3/4") or 51 mm (2")
bung on 208-liter (55-gallon) drum, preventing moisture-laden air
from contaminating polymer. Particularly useful in low-feed-rate
applications.
Model PB1
Drum suction wand
assembly mounts to 19 mm
(3/4") bung for convenient
feeding from drums.
Model
PSW75
Stainless-steel support
stand
allows elevation of unit
to convenient working height
where shelf, table or pedestal
mounting is not available.
Lower shelf on stand provides
convenient mounting location
for heavier motorized
metering pumps.
Model PST – for all models except
models PAD/PMD3000R
Model PST-32 – Available for
Models PAD/PMD3000R
Drum mixer
mounts to
51 mm (2") bung, allowing
occasional mixing of
55-gallon drums. Useful
for re-mixing drums that
have been stored or for
mixing drums that are
used in very low flow-rate
applications.
Mixer/desiccant
breather adapter
allows mounting of both
breather and drum mixer
on the 51 mm (2") bung,
reserving the 19 mm (3/4")
bung for a polymer drum
suction wand.
Model PMA
Calibration column kit
with
isolation valves mounts in polymer
pump suction line to allow precise
determination of polymer flow rate.
Part Number Range, lph (gph)
CK-100 0-11 (0-3)
CK-250 4-27 (1-7)
CK-1000 11-114 (3-30)
CK-4000 45-454 (12-120)
Polymaster Calibration Kit
Chemical Feed Products
Available From Neptune
•
•
•
•
•
Chemical Feed Products
Available From Neptune
•
•
•
•
•
1000
mL
CONNECT TO
POLYMASTER
CONNECT TO
POLYMER DRUM
7
208 L/S
(55 G/S) DRUM
51 mm
(2.0") NPT
BUNG HOLE
19 mm
(.75") NPT
DRUM WAND
19 mm
(.75") NPT
BUNG HOLE
DRUM
MIXER DESSICANT
DRYER