ProTeam ProGuard LI 3 Battery Charger - Manual (Page 8)

GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING: Do not allow brake fluids, gasoline, petroleum-based products,
penetrating oils, etc., to come in contact with plastic parts. Chemicals can damage,
weaken, or destroy plastic which may result in serious personal injury.
Only the parts shown on the replacement parts list of the Owner’s Manual are
intended to be repaired or replaced by the customer. All other parts should be
replaced at a ProTeam authorized service center.
BATTERIES
This charger will accept ProTeam 18-volt Lithium Ion battery packs.
Battery packs for this product have been designed to provide maximum, trouble-free
life. However, like all batteries, they will eventually wear out. Do not disassemble
battery pack and attempt to replace the battery cells. Handling of these cells,
especially when wearing rings and jewelry, could result in a serious burn.
To obtain the longest possible battery life:
• Remove the battery pack from the charger once it is fully charged and ready for
use.
• Store the battery pack in a cool, dry location, where the temperature is below
80°F.
For long-term storage, beyond 30 days, it is additionally recommended to:
• Store battery packs in a partially-charged state of about 30% - 50% charge.
• Charge the battery pack as normal for every six months of storage thereafter.
MAINTENANCE
!