NZXT Sentry LX - Manual (Page 6)

1. Press the “Fan Select” button to initiate fan settings.
Pushing the “Fan Select” button continuously will scroll
through the connections on the meter.
2. Push the “Up and Down Arrows” to adjust the fan speed,
note that doing this will set the meter into Manual mode.
The fan speed range that can be adjusted is
automatically detected by the fan controller. Setting a
fan to 0 RPM results in turning off the fan. Due to
information being passed between the meter and the
fan, please allow up to 1 minute for fans to adjust to the
RPM.
3. The Sentry LX will exit the “Fan Select” mode at after
idling or at the end of the “Fan Select” scroll.
Temperature Alarm Settings
The Sentry LX allows for alarm setting for temperatures, the default
is set at 70C, these settings will be saved. A sound alarm will go off if
the temperature detected rises above the set temperature. Please
follow the directions below:
1. Press and hold the triangular “Down Arrow Key” to
initiate temperature alarm setting.
2. Pushing the “SET” button to scroll through the
temperature settings for the 5 probes.
3. Use the “Up and Down Arrows” to adjust the
temperatures.
4. The Sentry LX will exit the temperature alarm setting
mode at after idling or at the end of the “SET” button
scroll.
Date, Time, Mode and Alarm Off Setting
In this mode the date, temperature alarm on/off, time, can be adjust.
Please follow the directions below:
1. Push the “SET” button to begin this mode.
2. Continue to push the set button to scroll through the
options
NZXT. 4