Kendall Howard 5500-3-00x-xx Training Table - Manual (Page 2)

Tools Needed:
2
Screw Driver
( 4x) Leveler
(25x) 1/4-20 Screw
(4x) End Cap
(1) Modesty Panel
(1) Table Top
(1) Left Leg
Assembly
(1) Surface Grommet
Included:
(1)Right Leg
Assembly
(1) Modesty Panel
Grommet
a. Position table top with smooth surface facing down
b. Line up leg assemblies with pre-drilled hole pattern
(note - shorter side of legs face the back of the table)
c. Fasten to table top with 1/4” screws
* If installing the Cable Management Enclosure leave out back
two screws in the legs
Assembly - Step 1:
3
Assembly - Step 2:
a. Attach modesty panel to the back edge of the right and left leg
assembly. (Make sure the grommet opening is closest to the
work surface)
b. Fasten with 1/4” screws.
** If not installing the Cable Management Enclosure—fill in additional
threaded holes in modesty panel with additional screws.
Assembly - Step 3:
a. Insert levelers into the threaded inserts in the bottom of the leg
assemblies.
b. Insert end caps into base of each leg kit.
*If installing the Cable Management Enclosure, proceed to mount that to
the modesty panel before assembling the panel to the training table