Kendall Howard 5200-3-510-00 LAN Station LCD Monitor Mount - Manual

Horizontal Adjustment Bolt
Adjustment Knob
Head Assembly
Nylon Washer
Bar Bracket
Tube Lock
Washer
Nut
Kendall Howard
Bar Mount LCD Monitor
Installation Instructions
The following instructions are universal for the Performance
and Performance Plus Series of LAN Station Workbenches.
1) Slide Bar Bracket on from the rear of the Accessory
Bar
2) Drop Head Assembly into the hole in the Bar Bracket
3) Place the tube lock under the bracket.
4) Add washer and tighten nut
5) Mount your flat screen monitor with the provided
screws
**NOTE**
Some larger monitors may require the use of the plastic
spacers provided in the hardware pack.
Adjustments
1) Use the provided hex wrench to adjust the tension on
the horizontal adjustment bolt
2) Use the adjustment knob to change the head
assembly position as required
WARNING!
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS
PERSONAL INJURY OR DAMAGE TO
EQUIPMENT. USING SCREWS OF IMPROPER
SIZE MAY DAMAGE YOUR DISPLAY. PROPER
SCREWS WILL EASILY AND COMPLETELY
THREAD INTO THE LCD MOUNTING HOLES.
REFER TO YOUR MONITOR MANUAL FOR MORE DETAILED INSTRUCTIONS ON PROPERLY
MOUNTING THE DEVICE.
Copyright © 2007 Kendall Howard LLC. All rights reserved