NXG Technology NX-622DVC - Manual

(Continued on reverse)
Where To Place Your Ceiling Speaker
Placement can make all the difference in how your speaker will sound, and how easy
it will be to install. Carefully consider where your speaker should be positioned. For
optimum performance, the speaker should be mounted as close as possible to the cen-
ter of the main listening area (See Fig. 2). Avoid mounting the speaker in stud cavities
containing electrical wiring, heating ducts, water pipes, etc. Make sure the wall or ceil-
ing materials are sturdy enough to support the weight of the speaker.
Speaker Installation In Existing Construction (See Fig. 3)
Once you have selected the location for your speakers, you are ready to install them.
You will need the following:
• Stud Finder • Drill & Drill Bits • Wire Cutter/ Strippers
• Pencil • Utility Knife or Drywall Saw • Small Level
• Masking Tape • Phillips Screwdriver • Speaker Wire
NXG recommends the use of a minimum of 16-gauge wire. For wire options consult
your retailer or custom audio contractor.
1. NXG Architectural Speakers are designed to be installed in the wall or ceiling area
between studs. Using a stud finder, make sure you are between two studs. Using the
supplied template, tape the template to the ceiling and lightly trace around the inside
with a pencil.
2. Cut the hole using your drywall saw. You may want to start with a small hole in the
center of the outline. This will allow you to check for any obstructions that may exist
behind the desired location. CAUTION: Be certain electrical wiring, water pipes or
heating ducts do not interfere in the planned installation areas prior to drilling or cut-
ting the wall.
3. Run speaker wire from your amplifier, volume control or speaker switching device
to the speaker location.
4. Carefully remove the grille and inner grille backing. (Note: The open cell foam inner
grille backing is designed to hide speaker components from view and may be removed
if desired.) If you like the standard white finish of your NXG
speakers, skip to step 5, but if if you want your speakers to
blend in with a colored wall or ceiling, now is the time to
paint your speaker’s outer frame and perforated grille.
(Remove the foam inner grille backing and put it aside in a
clean and dust free area for later reinstallation if desired.) The
speaker’s outer surface will accept ordinary latex wall paint or
aerosol spray paint. Because the speaker baffle surface
behind the grille should remain unpainted, you will need to
cover this area with the supplied cardboard paint mask.
Cover the speaker’s interior black surface, woofer and tweet-
er. Paint the outer speaker frame and grille separately. (Grille
painting hint: Use a paint roller that is nearly out of paint to
first paint the inside of the grille, then the outside. This will
avoid paint filling the grille perforations.)
Congratulations on choosing NXG In-Ceiling Loudspeakers. Like all NXG products,
great care has been taken in their design. Their combination of advanced engineering
and state-of-the-art materials will provide you with years of listening pleasure, while
blending smoothly into your home’s decor. Before you get started, it is a good idea to
identify all the parts and hardware (See Fig. 1).
FIG. 1
Speaker with self-contained
mounting clamps
Grille with foam
inner grille cover
FIG. 2
NX-622DVC Dual Voice Coil Ceiling-Mount Speaker System
OWNER’S MANUAL
Black grille
adhesive
FIG. 3
Cutout templates Painting masks