NXG Technology NX-VMS100 Impedance Matching Volume Control - Manual (Page 2)

One-Year Limited Warranty
If this volume control proves to be defective in materials or workmanship within one year from
the date of the original customers purchase, we will, at our option, repair or replace the defec-
tive product.
Disclaimer
The warranty stated herein is in lieu of all other warranties expressed or implied includ-
ing merchantability and fitness for particular purpose and all other liabilities and obligations of
NXG Technology, all of which are expressly disclaimed. NXG Technology has not made and does
not hereby make any other representation, warranty or covenant with respect to the condition,
quality, durability, design, operation, capacity, fitness for use or suitability of this volume control.
Exclusion of Certain Damages
NXG Technology’s liability for any defective product is limited to repair or replacement of the prod-
uct at our option. NXG Technology shall not be liable for incidental or consequential damages of any
kind or character because of product defects. Some states do not allow limitations on how long an
implied warranty lasts and/or do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitations and exclusions may not apply.
This Warranty Does Not Cover
Damage caused by abuse, accident, misuse, negligence or improper operation or installation.
Products that have been altered or modified. Any product whose serial number has been altered,
defaced or removed. Normal wear and maintenance. Damages caused by shipping (All claims for
shipping damages must be made with the carrier)
Warranty Service
All warranty repairs must be accompanied by the original
bill of sale. No other document is acceptable or required.
Mounting (Fig. 3)
Using the screws provided, install the
completed assembly into a single gang
electrical work box, approximately 18
cubic inches or greater. An open back
electrical box or plaster ring may be
more convenient to work with.
Note: Avoid mounting the NX-VMS100
next to AC lines or dimmers.
Operational Check
After making all connections, check for proper operation. Switch the system to the ON position. Using either the television or music, slowly
increase the volume on the amplifier/receiver to mid position. Now, slowly raise the volume control slider knob on the NX-VMS100, from its
minimum position up towards its maximum position. You should hear sound emanating from the speakers, increasing in volume as you raise
the volume control slider knob through its twelve steps. Select the level of sound that is most pleasing to you. If no sound is heard from any
or all speakers, switch the system OFF immediately and check for open or loose connections, wrong polarity or shorts in the wires.
Fig. 3
Wiring Instructions (Fig. 2)
The NX-VMS100 has detachable connector blocks to which the amplifier
and speaker wires should be connected. When connecting the speaker
leads from the amplifier outputs to the volume controls blue input con-
nector block, strip about an 1/8 inch of insulation from the wire and twist
or solder it so that there are no loose strands. Insert the wires from the
amplifiers outputs into the volume control connector block inputs.
Note: Wires should stay consistant right + from the amplifier to right + on
the input side of the connecting block. Most speaker wire has some form
of identification such as raised ribs or color coding to help determine pos-
itive and negative connections. Connect the speakers to the black output
connector block following the same format as above. When the wires are
connected to blocks, plug them back into the volume control input and
outputs. Do not apply undue pressure while plugging it into the socket.
Make sure the plug is engaged in the socket properly and is not loose.
Caution: Do not reverse the input and output connections or serious
damage may occur to your amplifier.
Fig. 2
NXG Technology • 16648 North 94th Street • Scottsdale, AZ 85260 • 1-800-733-0008