NXG Technology NX-HDMIM-4x2 - 4x2 Matrix - Manual (Page 2)

SPECIFICATIONS
Operating Temperature Range -5 to +35° C (-41 to +95° F)
Operating Humidity Range 5 to 90%RH (No Condensation)
Input Video Signal 0.5-1.0 Volts P-P
Input DDC Signal 5 volts p-p (TTL)
Data Transfer Speed Rate 6.75Gbps(Maximum)
Video Format Supported DTV/HDTV:480i/576i/480P/576P/720P/1080i/1080P
3D video support (Side-by-Side Horizontal)
HDMI Output HDMI 1.3 +HDCP 2.0
Support Video Color Format xv-YCC/deep color 36bit
Support Audio Format DTS-HD/true-HD/LPCM7.1/AC3/DTS/DSD
Transmission Distance 15m (Maximum) over standard HDMI cable/26AWG
Power consumption 5 watts (Maximum)
Dimension (L x W x H) 115 x 60 x 32mm
Net Weight 245g
Note: Specifications are subject to change without notice. Mass and dimensions are approximate.
PACKING CONTENTS
1) Main Unit. 4x2 HDMI Matrix 2) 5VDC 2A Power Supply.
3) Operating Instructions 4) Infrared Remote Controller
PANEL DESCRIPTIONS
2 3
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
CONNECTING AND OPERATING
1) Connect the HDMI signal sources into the desired HDMI inputs.
2) Connect each video display input into the A and B HDMI outputs on the Matrix.
3) Plug the 5VDC power supply into Power input.
4) Use the hand held remote control or press buttons on the front panel to select the input
signal source for output A and output B
5) Gently Insert/Extract cables.
6) Reset the power if there is no signal.
MAINTENANCE
Clean this unit with a soft, dry cloth. Never use alcohol, paint thinner or other harsh chemicals
to clean this unit.
PRODUCT SERVICE
1) Damage requiring service: The unit should be serviced by qualified service personnel if:
(a) The DC power supply cord or AC adaptor has been damaged;
(b) Objects or liquids have damaged the unit;
(c) The unit has been exposed to rain;
(d) The unit does not operate normally or exhibits a significant change in performance;
(e) The unit has been dropped or the cabinet damaged.
2) Servicing the unit: Do not attempt to service the unit beyond that described in these
operating instructions. Refer all other servicing to authorized servicing personnel.
8) Output A port 9) Power input 10) Input ports 11) Output B port
1) IR Receiver
2) Output B Select Button: Press the “Switch B” button to switch signal source from input 1 to 4.
3) Output A Select Button: Press the “Switch A” button to switch signal source from input 1 to 4.
4) HDMI output B Indicator: A red LED light will illuminate when output B is active.
5) HDMI output A Indicator: A blue LED light will illuminate when output A is active.
6) Output B Input Source Indicator: The corresponding red LED light will illuminate according
to the selected input.
7) Output A Input Source Indicator: The corresponding blue LED light will illuminate according
to the selected input.
Left Panel Rear Panel Right Panel
Front Panel
Remote