NXG Technology NX-HDMIM-4x4 - 4x4 Matrix - Manual (Page 2)

PANEL DESCRIPTIONS
2 3
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
TABLE OF CONTENTS
Introduction
Package Contents
Panel Descriptions
Connect and Operation
Specifications
Warranty & Service
PACKAGE CONTENTS
1) Main unit. 4x4 HDMI Matrix
2) 5VDC Power Supply
3) 1x Remote.
4) 4x IR-TX cable
5) 4x IR-RX cable
6) 4x IR-RX cable extender jacks
7) Operating Instructions
Front panel
1) Power switch
2) IR TX out 1 to 4
3) IR window
4) Output and Input selection / indicator
5) Locking status indicator
6) Key lock selection
7) USB port for ISP only, firmware upgrade port
8) DIP switch
TYPICAL APPLICATION
MAINTENANCE
Clean this unit with a soft, dry cloth. Never use alcohol, paint thinner or other harsh chemicals
to clean this unit.
IR receiver cable extender jacks.
When the display device is not near to the matrix, the IR cable will be too short. There is a pair
of jacks supplied for extending the IR (RX) cable. Please use an appropriate (min. 3 conductor
shielded audio cable) or an additional CAT5e /CAT6 cable to form the IR cable extender.
Additional wires unused should be grounded at the connector on the Matrix end of the line only.
Use the male jack and female jack to extend the IR_RX cable like the picture below.
Tip = IR Signal, Ring = Power, Sleeve = IR Ground
1 3 4 5 6
7 8
2