NXG Technology NX-HDMIX-IR-50 - HDMI over dual Cat5e/6/7 - Manual (Page 2)

TABLE OF CONTENTS
Specifications
Package Contents
Panel Descriptions
Connecting and Operating
Maintenance
Product Service
Warranty
SPECIFICATIONS
Operating Temperature Range -5 to +35° C (-41 to +95° F)
Operating Humidity Range 5 to 90%RH (No Condensation)
Input Video Signal 0.5-1.0 Volts P-P
Input DDC Signal 5 volts p-p (TTL)
Support Video Format DTV/HDTV:480i/576i/480P/576P/720P/1080i/1080P
HDMI Output Compliant with HDMI 1.3, HDCP 1.1
Support Audio Format DTS-HD Master Audio0Dolby true-HD etc.
Transmission Distance 1080P 8-bit 50m(Maximum) over CAT5E/CAT6 /24AWG/Solid
(recommend to use 23AWG Cat6 cable)
Power consumption 3 watts (Maximum)
Dimension (L x W x H) 83 x 46 x 23mm
Net Weight 213g (Pair)
Note: Specifications are subject to change without notice. Mass and dimensions are approximate. When in
36Bit deep color mode, we suggest setting the HDMI source device to output 1080i or 720p.
PACKING CONTENTS
1) Main Unit. Transmitter & Receiver 2) IR-TX cable & IR-RX cable
3) DC5V Power Supply 4) Operating Instructions
PANEL DESCRIPTIONS
Transmitter Panel
2 3
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
Receiver Panel
6) Status of signal connection 7) HDMI output 8) Status of power input
9) IR-RX input 10) Power input 11) RX CAT-5E/6 input 1/input 2
CONNECTING AND OPERATING
1) Connect the HDMI from the source to HDMI Input of the transmitter.
2) Connect two Cat5e/Cat6 cables to the outputs of the transmitter and inputs of the Receiver.
Make sure to keep the correct cable connection on two cables, 1 to 1 , 2 to 2
(The cables connections at the RJ45 connector must follow EIA-TIA 568B standards).
3) Connect the RX HDMI Output into the display source
4) Connect IR-RX cable into IR-RX input and affix the IR receiver in direct line of sight adjacent
to the display
5) Connect IR-TX cable into IR-TX end and affix the emitter on the source IR window
6) In some cases the power adapter isn’t needed. However, the power adapter is needed when
the signal source doesn’t sufficiently drive 5V long distances.
NOTE: Gently Insert/Extract all cables.
MAINTENANCE
Clean both units with a soft, dry cloth. Never use alcohol, paint thinner or other harsh chemicals
to clean this unit. While dusting, be careful not to knock off the IR emitter or IR receiver from
their affixed locations.
PRODUCT SERVICE
1) The unit should be serviced by qualified service personnel if:
(a) DC power supply cord or AC adaptor has been damaged
(b) Objects or liquids damaged the unit
(c) The unit has been exposed to rain
(d) The unit does not operate normally or exhibits a change in performance
(e) The unit has been dropped and the cabinet damaged
2) Do not attempt to service the unit beyond what is described in this manual.
1) HDMI input 2) Status of signal connection 3) Status of power input
4) IR-TX input 5) TX CAT-5E/6 output1/output2