NXG Technology NX-HDMIX-IR-30 - HDMI over dual Cat5e/6/7 - Manual (Page 2)

TABLE OF CONTENTS
Specifications
Package Contents
Panel Descriptions
Connecting and Operating
Maintenance
Product Service
Warranty
SPECIFICATIONS
Operating Temperature Range -5 to +35° C (-41 to +95° F)
Operating Humidity Range 5 to 90%RH (No Condensation)
Input Video Signal 0.5-1.0 Volts P-P
Input DDC Signal 5 volts p-p (TTL)
Video Format Supported DTV/HDTV:480i/576i/480P/576P/720P/1080i/1080P
HDMI Output Compliant with HDMI 1.3, HDCP 1.1
Support Audio Format DTS-HD Master Audio0Dolby true-HD etc.
Transmission Distance 1080i 8-bit 50m(Maximum); 1080 8-bit 30m (Maximum);
1080P 12-bit 25m(Maximum) over CAT5E/CAT6 /24AWG/Solid
(recommend to use 23AWG Cat6 cable)
Power consumption 3 watts (Maximum)
Dimension (L x W x H) 66 x 45.5 x 25mm
Net Weight 180g (Pair)
Note: Specifications are subject to change. Mass and dimensions are approximate.
When in 36Bit deep color mode, we suggest setting the source device to 1080i or 720p.
PACKING CONTENTS
1) Transmitter (TX) & Receiver (RX) 2) IR-TX emitter cable & IR-RX receiver cable
3) DC5V Power Supply 4) Operating Instructions
PANEL DESCRIPTIONS
2 3
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
RECEIVER (RX)
1) Signal Status
2) IR-TX input
3) HDMI input
4) Power Status
5) CAT-5E/6 output
6) IR-RX input
7) HDMI output
8) Power input
9) CAT-5E/6 input
CONNECTING AND OPERATING
1) Connect the HDMI output from the source to HDMI Transmitter (TX).
2) Connect two Cat5e/Cat6 cables to the outputs of the transmitter (TX) and inputs of the
Receiver (RX). It is important to maintain the correct connections of the two cables,
1 to 1 and 2 to 2. Note: The cable connections must follow EIA-TIA 568B standards
3) Connect the HDMI output from the Receiver (RX) unit into the display input desired.
4) Connect IR-RX cable into IR-RX input and affix the IR receiver in direct line of sight with
the handheld remote. In most cases, we would suggest placing the IR receiver on the
display bezel. Note: Gently Insert/Extract cables
5) Connect the IR-TX cable into IR-TX connection on the transmitter (TX) and affix the
emitter on the source IR window. Emitter placement is important so test the location of
the IR source control before permanently affixing the emitter on the source.
MAINTENANCE
Clean this unit with a soft, dry cloth. Never use alcohol, paint thinner or other harsh chemicals
to clean this unit.
PRODUCT SERVICE
1) Damage requiring service:
The unit should be serviced by qualified service personnel if:
(a) The DC power supply cord or AC adaptor has been damaged;
(b) Objects or liquids have damaged the unit;
(c) The unit has been exposed to rain;
(d) The unit does not operate normally or exhibits a significant change in performance;
(e) The unit has been dropped or the cabinet damaged.
2) Do not attempt to service the unit beyond that described in the operating instructions.
Refer all other servicing to authorized servicing personnel.
TRANSMITTER (TX)