NXG Technology NX-VMS1003C - Slide Style Impedance Matching Volume Control - Manual (Page 2)

Changing Volume Control Color (Fig. 2)
The NX-VMS1003C comes in your choice of three colors – white, almond, or ivor y. The NX-VMS1003C is packaged with the white insert and
slider knob already attached. If white is your color choice, continue to the next section (“Wiring and Installation”). If you prefer to change the
color of your volume control, that can easily be achieved by following the steps in Fig. 2 below.
Push the slider knob all
the way to the bottom.
Using your index fingers, gently press down and out on
the two top tabs located on the rear of the white plastic
insert plate. The top of the insert plate should come loose.
Gently lift the plate and pull forward. This
will release the bottom two tabs, allowing
the insert plate and slider knob to be
completely removed.
Select the color insert plate and matching
slider knob of your choice. Holding the
slider knob in a vertical position, press it
against the facing of the insert plate. Twist
the slider knob in a horizontal position,
making sure the tabs snap under the lip of
the frame surrounding the insert plate.
White insert plate
Metal
mounting plate
Tabs
Push the slider knob all the way to the
bottom. Make sure that the black slider on
the metal mounting plate is also pushed
to the bottom. This allows the slider knob
on the insert plate to match up with the
black slider when you attach them.
Align the four tabs on the back of
the insert plate with the slots on
the metal plate. Snap the insert
plate back into place.
Removing the Insert Plate
Fig. 2