Gorman-Rupp Pumps T2A60-B /F,/FM - Manual (Page 32)

OM-05137 T SERIES
MAINTENANCE & REPAIR PAGE E - 9
The bearing tolerances provide a tight press fit
onto the shaft and a snug slip fit into the bearing
housing. Replace the bearings, shaft, or bearing
housing if the proper bearing fit is not achieved.
If bearing replacement is required, remove the out­
board bearing retaining ring (25), and use a bear­
ing puller to remove the bearings from the shaft.
Press the inboard oil seal (7) from the bearing
housing.
Shaft and Bearing Reassembly and Installation
(Figure 2)
Clean the bearing housing, shaft and all compo­
nent parts (except the bearings) with a soft cloth
soaked in cleaning solvent. Inspect the parts for
wear or damage as necessary.
Most cleaning solvents are toxic and
flammable. Use them only in a well ven­
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain­
ers.
Inspect the shaft for distortion, nicks or scratches,
or for thread damage on the impeller end. Dress
small nicks and burrs with a fine file or emery cloth.
Replace the shaft if defective.
Position the inboard oil seal (7) in the bearing hous­
ing bore with the lip positioned as shown in Figure
2. Press the oil seal into the housing until the face is
just flush with the machined surface on the hous­
ing.
To prevent damage during removal from
the shaft, it is recommended that bearings
be cleaned and inspected in place. It is
strongly recommended that the bearings
be replaced any time the shaft and bear­
ings are removed.
NOTE
Position the inboard bearing (9) on the shaft with
the shielded side toward the impeller end of the
shaft. Position the outboard bearing (27) on the
shaft with the integral retaining ring on the bearing
O.D. toward the drive end of the shaft.
The bearings may be heated to ease installation.
An induction heater, hot oil bath, electric oven, or
hot plate may be used to heat the bearings. Bear­
ings should never be heated with a direct flame or
directly on a hot plate.
NOTE
If a hot oil bath is used to heat the bearings, both the
oil and the container must be absolutely clean. If
the oil has been previously used, it must be thor­
oughly filtered.
Heat the bearings to a uniform temperature no
higher than 250
_F (120_C), and slide the bearings
onto the shaft, one at a time, until they are fully
seated. This should be done quickly, in one con­
tinuous motion, to prevent the bearings from cool­
ing and sticking on the shaft.
After the bearings have been installed and allowed
to cool, check to ensure that they have not moved
away from the shaft shoulders in shrinking. If
movement has occurred, use a suitably sized
sleeve and a press to reposition the bearings
against the shaft shoulders.
If heating the bearings is not practical, use a suit­
ably sized sleeve, and an arbor (or hydraulic) press
to install the bearings on the shaft.
When installing the bearings onto the
shaft, never press or hit against the outer
race, balls, or ball cage. Press only on the
inner race.
Secure the outboard bearing on the shaft with the
bearing retaining ring (25).
Slide the shaft and assembled bearings into the
bearing housing until the retaining ring on the out­
board bearing seats against the bearing housing.