Lubrication – Gorman-Rupp Pumps 16C2-F4L 913960 thru 1013565 User Manual

Page 34

Advertising
background image

10 SERIES

OM−00725−06

MAINTENANCE & REPAIR

PAGE E − 16

cure it with the hardware (50 and 51). The wear
plate must be concentric to prevent binding when
the back cover is installed.

Clean any scale or debris from the contacting sur-
faces in the pump casing that might interfere or
prevent a good seal with the back cover. Replace
the back cover gasket (53) and slide the back
cover assembly into the pump casing. Be sure the
wear plate does not bind against the impeller.

NOTE

To ease future disassembly, apply a film of grease
or ‘Never-Seez’ on the back cover shoulder, or any
surface which contacts the pump casing. This ac-
tion will reduce rust and scale build-up.

Secure the back cover assembly by tightening the
cover clamp screw (59). Do not over-tighten the
clamp screw; it should be just tight enough to en-
sure a good seal at the back cover shoulder.

Final Pump Assembly

(Figure 1)

Install any leveling shims used under the pump
casing mounting feet and secure the casing to the

base (46) with the hardware (47, 48 and 49). Be
sure the pump is secured to the base and engine.

Install the suction and discharge lines and open all
valves. Make certain that all piping connections are
tight, properly supported and secure.

Be sure the pump end and engine have been
properly lubricated, see LUBRICATION.

Remove the fill cover assembly (23). Fill the pump
casing with clean liquid. Reinstall the fill cover plate
and tighten it.

Refer to OPERATION, Section C, and start the
pump.

LUBRICATION

Seal Assembly

(Figure 2)

Fill the grease cup (17) through the grease fitting
with No. 2 lithium base grease until grease es-
capes from the relief hole. Turn the grease cup arm
counterclockwise until it is at the top of the stem;
this will release the spring to apply grease to the
seal (see Figure 5).

GREASE

FITTING

CROSS

ARM

POSITION

WHEN

EMPTY

POSITION

FOR

FILLING

POSITION

WHEN

IN USE

RELIEF

HOLE

Figure 5. Automatic Lubricating Grease Cup

Advertising