Gorman-Rupp Pumps 16A2-4045T 1514795 and up User Manual
Page 38
10 SERIES
OM-06540
MAINTENANCE & REPAIR
PAGE E - 18
the hole for the oil hole cover (31). Do not over‐lu
bricate. Over‐lubrication can cause the bearings to
over‐heat, resulting in premature bearing failure.
NOTE
The white reflector in the sight gauge must be posi
tioned horizontally to provide proper drainage.
Under normal conditions, drain the intermediate
once each year and refill with approximately 7-1/2
ounces (22 ml) of clean oil. Change the oil more fre
quently if the pump is operated continuously or in
stalled in an environment with rapid temperature
change.
Monitor the condition of the bearing lubri
cant regularly for evidence of rust or mois
ture condensation. This is especially im
portant in areas where variable hot and
cold temperatures are common.
For cold weather operation, consult the factory or a
lubricant supplier for the recommended grade of
oil.
Engine
Consult the literature supplied with the power
source, or contact your local John Deere engine
representative.