AAEON ACD-518R - Manual (Page 22)

R e m o t e T o u c h D i s p l a y A C D - 5 1 8 R
Chapter 2 Hardware Installation 2-4
2.3 VESA Wall Mounting
Mounting the LCD Display with UL Listed Wallmount Bracket only. The
LCD Display can be mounted on a monitor arm or wallmount plate.
Caution:
When mounting the LCD Display, take care to tighten the retention
screws or bolts until fully secured, but do not over tighten. Over tighting
the retention screws or bolts may cause them to become stripped,
rendering them useless.
Monitor Arm or Wallmount Plate Installation
The LCD Display has Video Electronics Standards Association (VESA)
standard mounting holes tapped into the rear panel. The standard holes
are M4 set at 75mm x 75mm apart.
VESA Mounting Holes
To mount the LCD Display onto a monitor arm or wallmount plate, please
follow the steps below.
Step 1: Line up the threaded holes on the monitor rear panel with
the screw holes on the monitor arm or wallmount plate.
Step 2: Secure the monitor to the arm or stand with the retention screws
supplied with the monitor arm or stand.