AAEON ACD-518R - Manual (Page 26)

R e m o t e T o u c h D i s p l a y A C D - 5 1 8 R
Chapter 2 Hardware Installation 2-8
2.7 Connecting Power of Remote Display
Use the provided AC-DC adapter and the power cord to connect the power
output socket of the monitor to turn on the power.
A ”Surge Protection” device plugged between the AC-DC adapter and the
wall outlet is recommended to prevent the effects of sudden current
variations from reaching the LCD monitor. The sudden peaks of electricity
may harm the LCD monitor.
2.8 Connecting I/O Connectors of Remote Display
 Turn off the computer and the LCD monitor before connecting them.
 Use the RJ-45 CAT5/6 cable to connect to the RJ-45 connector.
 Connect USB devices to the USB connectors.
2.9 Connection Debugging
If the connection or display cannot work well, please refer to the debugging
steps below.

Make sure that all the cables are connected tightly.

After the computer/display powered on, you will see the display that
is reaching the local and remote IP below.

Local IP: The IP address of the display
If the display cannot find the local IP as shown, it means the
network connection/cabling has some issues

Remote IP: The address of the remote box, such as ACG-203
or ACG-204
If the display cannot find the remote IP, it means the remote