ABUS HSRM20000 wireless smoke alarm device - Manual (Page 32)

12
1) Press the test button on the detector for approx. 2 seconds, until the LED flashes
slowly, roughly once a second. The detector is now in addressing mode.
2) Press the test button on the second detector for approx. 2 seconds to set this
detector in addressing mode too.
3) The detectors exit addressing mode automatically after 60 seconds.
4) The addressing process can take up to 60 seconds. When the detectors have been
successfully trained, the LED on both detectors lights up for around 5 seconds,
after which the detectors exit addressing mode. If this was not successful, the
detector will return to standard mode automatically after 60
seconds.
5) If you wish to connect several detectors together, you will
need to define a central detector, with which you can
connect the other detectors. Proceed with points 1 to 4 as