ABUS HSRM20000 wireless smoke alarm device - Manual (Page 33)

13
described to connect the detectors in a network.
6) The detectors will exchange their addressing data with another.
Reset default factory settings/separate network connections
In order to reset the smoke detectors to the default factory settings
Press the test button and hold it down.
After approx. 2 seconds the LED will flash once a second. After another 5 seconds
the LED will flash more frequently (approx. twice a second).
Now let go of the button. If a short beep is heard, the procedure was successful.
All network connections between the detectors have then been separated.
Muting the detector
If an alarm has been triggered, the wireless smoke detector can be muted by pressing the
test button.
Please note that the muting only applies to the detector whose test button has been
pressed. The mute remains active until the alarm is automatically reset. See the following
table for differences in the signal when the detector is muted.