ABUS TV7019 - Manual (Page 17)

7. Installation
Proceed as follows when installing the camera.
1. Select a suitable place on the ceiling of the room where you would like to
mount the camera.
2. Change the aperture of the camera housing according to the mounting
variant (flush or surface mount).
3. Connect the video cable (recommended cable type: RG58) to the BNC
video out (1) of the camera and to the following connected video unit. The
maximum cable length should not exceed 200 m.
4. Connect a 12V DC power supply to the power input of the camera (2).
5. Hold the camera at the location where you want to mount it. Check the
orientation and angle of the camera.
6. Change the orientation of the camera module if necessary by applying a
little pressure to press the camera module slightly into the camera housing
and thereby altering the position.
7. Fasten the flush mount / surface mount camera to the desired installation
location using the supplied screws (3).
8. If no picture appears on the monitor, check the following:
• Is the monitor switched on and is the level of contrast and brightness set
correctly?
• Is the video cable between the camera and monitor connected properly
(also check the resistor settings)?
• Is the power supply connected?
• Is the illumination where the camera is located sufficient for this camera
model?
17