ABUS TVAC21000 - Manual (Page 37)

34
English
If you select ‘ON / OFF Time’, you can set the start time for motion detection as the ‘ON TIME’ and the
end time as the ‘OFF TIME’. Motion detection is only activated during this period.
If you select ‘ALWAYS OFF’, motion detection is always deactivated.
SENSITIVITY
Sets the sensitivity of motion detection in a range from -7 (MIN) to 7 (MAX). The lower the sensitivity, the
more movement is required for an alarm to be triggered.
VELOCITY
Selects the velocity at which changes to the picture are interpreted as motion. The range is between -7
(MIN) and 7 (MAX).
The lower the velocity is set, the faster an object must move in order to trigger an alarm.
MASKING AREA
Defines the area of the camera picture in which a motion is detected. A maximum of 192 fields (16
columns x 12 rows) are available.
Select the detection area as follows:
• Press [↑] and [↓] in the menu to select “MASKING AREA”.
• Press [↑] and [↓] to move the cursor (red rectangle) up and down the screen, and [-] and [+] to
navigate left and right.
• Press [ENTER] to select a field for motion detection (red field) or unselect it (clear field).
• Quit the ‘Masking Area’ by pressing [↑] and [↓] above the edge of the miniature camera picture.
8.6 Event settings
Event Setup Ver 1.20
Buzzer / Report Control
CH NO 1 2 3 4 5 6 7 8
LOSS ■ ■ ■ ■
MOTION □ □ □ □
BUZZER HOLD TIME: 05 S
REPORT HOLD TIME: 10 S
MD FREEZE TIME OFF
ЧШХЦ SELECT ON EXIT
Fig. 10: Event settings
Activate or deactivate the picture loss alarm for cameras 1 to 4 by pressing [ENTER] in the corresponding
box.
BUZZER HOLD TIME
Sets the time for the alarm tone (range: 0–99 seconds). To disable the alarm tone function, select 0
(“OFF”).