ABUS TVVR30004 Operating instructions - Manual (Page 83)

Configuration
83
Note
Activate remote access
Activate this function to enable optimum technical
support.
TAB “DST set-
tings” Setting
Auto DST Ad-
justment With an activated check box, the de-
vice converts automatically to summer
time.
Enable DST With an activated check box, an exact
start / end date can be selected
From / To Date of DST start / end
DST Bias Daylight Saving Time Bias: Correc-
tion of the DST to the reference time
TAB “More
Settings” Setting
Device Name Unique specification of the device
Device Number Used for unique identification when
using remote control
CVBS Output
Brightness Scroll bar (left = darker;
right = brighter)
Operation
Timeout Never / 1 to 30 minutes – regulates
how long the menu is shown
Output mode
menu Renders the image softer or sharper
Event message Box ticked:
Automatic alarming when notifica-
tions such as motion detection , HDD
full, etc. occur.
Confirm the settings by clicking Apply and leave the
menu with OK.
Network configuration
Correct network settings are essential in the following
cases:

When using remote control of the device and surveil-
lance over your server
Note
Please read the following basic instructions before
setting up the device.
A network is a connection of at least two network-capable
devices.
Transmission types:

Wired networks (e.g. CAT5 cable)

Wireless networks (WLAN)

Other transmission types (Powerline)
All systems have certain similarities, but can also differ in
many ways.
Terms and definitions
An overview of relevant terms when using the device in a
network can be found below.
Parameter Setting
IP address An IP address is the unique address of a
network device within a network.
This address may only appear once with-
in a network. Certain IP address ranges
are reserved for public networks (e.g. the
Internet).
Private
address
range e.g. 10.0.0.0 – 10.255.255.255
Subnet mask: 255.0.0.0
172.16.0.0 - 172.31.255.255
Subnet mask: 255.255.0.0
192.168.0.0 - 192.168.255.255
Subnet mask: 255.255.255.0
Subnet
mask A subnet mask is a bit mask used for
making decisions and assignments dur-
ing routing.
255.255.255.0 is the standard subnet
mask in home networks.
Gateway A gateway is a network device which al-
lows all other network devices to access
the Internet.
This can be the computer connected to
the DSL modem or
– usually – the router
or access point within the network.
Parameter Setting
Name
server The name server is responsible for as-
signing a unique IP address to a web ad-
dress or URL (e.g. www.google.de). Also
known as DNS (Domain Name Server).
When a domain name is entered into a
browser, the DNS searches for the cor-
responding IP address of the server and
forwards the query on.
The IP of the provider’s DNS can be en-
tered here. However, it is often sufficient
to select the IP of the gateway. This then
forwards the queries independently to the
provider DNS.
DHCP The DHCP server automatically assigns
the IP address, subnet mask, gateway
and name server to a network device.
DHCPs are available in current routers.
The DHCP service must be specially set
and activated (see the corresponding
manual for more information).
Note:
When using fixed IP addresses and a
DHCP server, make sure that the fixed IP
addresses are outside the address range
assigned by DHCP. Otherwise, problems
could occur.