ABUS TVCC81000 Operating instructions - Manual (Page 29)

29
4. Device description
4.1 Overview
– Model numbers
Model number TVCC80000 TVCC81000
Resolution 540 TVL 540 TVL
IP66 -

Operating voltage 24 V AC 24 V AC
4.2 Unpacking the device
Handle the device with extreme care when unpacking it.
If the original packaging has been damaged, inspect the device. If the device shows signs
of damage, return it in the original packaging and inform the delivery service.
5. Installation
Instructions and installation variants for the dome cameras can be found in the quickstart installation
guide.
Please consult this guide before you proceed with the installation.
6. Control devices quickstart guide
The high-speed motorised dome can be controlled with all RS485 devices that have the Pelco D or
Pelco P protocol.
For additional information, please refer to the relevant user guide.
6.1 Control with control panel TVAC26000
The control panel TVAC26000 was especially developed for control of high-speed motorised dome
TVCC8x000 and therefore supports all functions of the cameras.
For all further information on connection and operation, refer to the instruction manual of the control
panel.
6.2 Control with recorder HDVR 3.0
You have the option to control your high-speed motorised dome with the HDVR.
The following steps are necessary for this.
1. Connect the RS-485 cables to the interface for control on the HDVR.
2. Incorporate the analogue camera in the software. For more details, see the appropriate user
guide.
3. Activate the pan/tilt control.
4. As the protocol type, choose ABUS Security-Center TVCC8x000.