ABUS TVHD80110 Operating instructions - Manual (Page 88)

Configuration
88
SNMP
Parameter Setting
Activate SNMP Activate the checkbox to create a
connection to SNMP software
SNMP version Version of the SNMP system
SNMP port Enter the SNMP port
(Default: 161)
Read community Enter the “Key” according to the set-
tings of your SNMP software.
Write community Enter the “Key” according to the set-
tings of your SNMP software.
Trap address Enter the IP address of the
SNMP manager
Trap port Enter the trap port
(Default: 162)
Note
SNMP is used for monitoring the device status.
For this you need SNMP software not available
from ABUS.
Confirm the settings by clicking Apply and exit the menu
with Back.
UPnP
Parameter Settings
Enable UPnP Tick box to activate visibility in an IP
network.
Mapping Type Select here whether port mapping is
to be conducted automatically or
manually.
Confirm the settings by clicking Apply and exit the menu
with Back.
More settings
Parameter Setting
Alarm Host IP Network address of the PC where the
CMS is installed
Alarm Host Port Port of your CMS Station
Server Port Port for data communication (Gen-
eral: 8000)
HTTP Port Port for web server (General: 80)
Multicast IP In order to minimize traffic you can
enter a Multicast IP. The IP address
has to match the IP address of the
PC running the CMS software.
RTSP Service
Port RTSP-port
(Default: 554)
Note
Server port 8000 and HTTP port 80 are the stand-
ard ports for remote clients and remote Internet
browser access.
Note
With Alarm Host IP/Port you configure the address
of your CMS software. The CMS software is noti-
fied when there is an alarm, and performs various
reactions depending on the setting.