ABUS TVAC26000 - Manual (Page 22)

22
English
5.2 Changing the protocol and baud rate
The example below describes how you can change the protocol in Pelco-D and the baud rate to 4800 for
Speeddome 002:
1. From the standby mode (Fig. 1), press and hold down the “Setup” button for three
seconds (Fig. 2).
2. Enter the password (Fig. 3, standard password: 8888).
3. Press “Enter” to go to the Setup menu. Navigate with the joystick to PTZ SETUP (Fig. 4).
4. Press “Enter” to go to the PTZ menu.
5. Move the joystick to the left or right to select the Speed Dome address (Fig. 5). Then
press “Enter” to confirm the changes (Fig. 6).
6. Move the joystick up and down to select the protocol (Fig. 7).
7. Move the joystick to the right to change the baud rate (Fig. 8). Then move the joystick to
select the baud rate (Fig.9).
8. Press “Enter” followed by “ESC” until you are in standby mode.
(Fig. 1).
9. The configuration is now complete.
DVR ：01 DVR ：01
ENTER PW:：
DVR ：01
ENTER PW : ****
Fig. 1 Fig. 2 Fig. 3
PW
SYS SETUP
PTZ SETUP
PW
P : PELCOP
CAM :
002
BR: 096
PW
CAM :
002
BR: 096 P : PELCOP
Fig. 4 Fig. 5 Fig. 6
PW
CAM :
002
BR: 096 P : PELCOD
PW
CAM :
002
P : PELCOD BR: 096
PW
CAM :
001
P : PELCOD BR: 048
Fig. 7 Fig. 8 Fig. 9