Alpha Technologies Micro, Micro XL, Micro XL3 UPS - Manual (Page 22)

017-237-B0 Rev A 20
5.3.4 Mounting to a Wall
Tools and Materials Required:
• 13 mm nut driver for the bolts that attach the cabinet to the mounting bracket.
• Four 1/4" x 1-1/8" lag bolts.
• Four 1/4" diameter flat washers.
• Drill with 1/8" bit for drilling pilot holes.
• Assorted sockets and wrenches.
Procedure
1. Using the mounting bracket as a template, drill 4 pilot holes (indicated by the arrows in Figure 6.7) into the
wall to accept 1/4" bolts.
2. Secure the mounting bracket to the wall with the 4 bolts and washers.
If the wall structure is not strong enough to support the weight of the Alpha Micro enclosure and batteries, use a
wooden backing plate that has a minimum thickness of 1-1/4" and a maximum width of 4" that is securely mount-
ed to a wall stud or studs.
3. Secure the Alpha Micro enclosure to the mounting bracket with the supplied bolts.
Front Side
Wall or
studs
Figure 14 — Attaching the mounting bracket to the wall studs