Alpha Technologies BSM-3 Battery Side Module Enclosure - Manual (Page 17)

1. Installation
17
033-082-C0-002 Rev. B
Tools and Materials Needed:
Foam insulation (supplied)
Utility knife
Procedure:
CAUTION: To prevent thermal overload of the power supply
and batteries, an insulating pad MUST be placed in
the power supply compartment of the UPEM enclosure.
1. Insulation pads are pre-cut to proper size. When installing on the left
side of the enclosure, use the 12” X 13.5” pad. When installing on
the right, use the 7” X 13.5” pad. Insulate only the side facing the
BSM-3.
2. Peel the cover off the adhesive, and place against the side of
the enclosure, as shown below. Dispose of unused insulation pad.
1.4 Insulation Installation
Fig 1-5 Insulation Placement
Place Pad Here
Place Pad Here
BSM-3 mounted on the right
BSM-3 mounted on the left
Place insulation pad
here when BSM is
mounted on the right
7"
13.5"
Place insulation pad
here when BSM is
mounted on the left
12"
13.5"
1.4.1. Insulation Pad Placement