American Expedition Vehicles JK Premium Front Bumper - Manual (Page 5)

3
II. VEHICLE PREPERATION
A. MODIFY FOG LIGHT WIRING FOR PREMIUM BUMPER ONLY
(NOTE: 2007-2009 USA, CANADA, AND MEXICO MODELS ONLY)
1. The fog lights are mounted further apart than factory, so the wiring harness needs to be re-posi-
tioned. This is accomplished by removing the factory conduit and re-routing the harness above the
frame rails. BE CAREFUL NOT TO CUT THE HARNESS!
2. Remove the tape from the wire harness at both ends to expose the loose length of wires.
3. Extend the harness outboard as much as possible to reach the new fog light location.
4. Replace the conduit, if it has been removed, and re-tape the modified harness.
5. Route the harness along the bottom of the grille and fasten to power steering line using cable ties.
Original Wiring Position Remove Tape