American Expedition Vehicles JK Hemi Builder Kit - Installation Guide for 07-11 JK Wrangler - Manual (Page 13)

10
Fig. 2
c. installation of the transmission mount
1. All 5–45 Transmissions must have the 3/4 Ton or 1 Ton Dodge 4WD adapter
(Mopar 52119433AB) installed prior to the transmissions mount.
2. Install the AEV Mount to the 4WD Adapter on the transmission using the stock bolts.
3. Install the stock JK transmission isolator to the AEV Transmission Mount using the two
3/8” x 1” bolts, nuts, and washers and two 1/2” x 1” bolts, nuts, and washers.
D. installation of the cross-member mount
1. Begin by bolting the top plate of the transmission cross member mount to the JK transmis-
sion isolator using the stock hardware.
2. Bolt the top plate of the transmission cross member mount to the JK cross member using 4
of the 1/2”–13 bolts, washers, and flange nuts.
3. Bolt the top plate of the transmission cross member mount to the bottom of the JK cross
member using three of the stock bolts into the cross member nutserts. Drill out one hole
using the bottom plate as a drill template. Use the remaining two 1/2”–13 bolts, washers
and flange nuts to secure the bottom plate to the cross member.
4. Weld top and bottom plates as shown (Figure 3.)
5. Paint any raw material and welds.