American Expedition Vehicles TJ Highline Body Kit - Manual (Page 2)

Page 2 of 13
PLEASE READ BEFORE YOU START
IN ORDER TO INSTALL THIS KIT PROPERLY YOU OR YOUR INSTALLER / PAINTER
MUST READ THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING THE
INSTALLATION. FAILURE TO DO SO MAY RESULT IN MISTAKES AND AFFECT THE
QUALITY OF THE FINISHED PRODUCT.
IF YOU ARE PLANNING ON HAVING THE KIT PAINTED PRIOR TO INSTALLATION, YOU
WILL NEED TO PURCHASE OR LOCATE A SET OF HOOD HINGES AND HINGE BACKING
PLATES. THE HINGES MUST BE INSTALLED ON THE HOOD PRIOR TO PAINT.
Included Parts QTY
Fender assembly, Right 1
Fender assembly, Left 1
Battery bracket, Right 1
Battery bracket, Left 1
U nut, battery bracket 2
Nut, flare mounting M5-.8 6
Sealer, thumb grade 1
Hood Perf 1
Nut, perf mounting 6
Flare, Right front 1
Flare, Left front 1
Flare, Right rear 1
Flare, Left rear 1
Required Tools
Common Hand Tools
Torx Bit (T40)
Metal Cutting Tool For Trimming
(Die Grinder, Cut Off Wheel, Sawzall)
Touch Up Paint
File or De-Burring Tool
Jack or Lift
Body Shims
Drill Motor
Drill Bits
Razor Knife
De-Burring Tool
Painters Tape
Spring Loaded Center Punch
Hammer