Atec Anritsu_MT8801C - Manual (Page 10)

Intuitive Key Layout, Simple Operation
10
ᕡ Keys corresponding to on-screen function keys.
The number of displayed function keys can be
increased using the Page key.
ᕢ Keys for inputting measurement parameters.
ᕣ Keys for selecting single or continuous measure-
ment.
ᕤ Keys for moving cursor and opening/closing the
parameter setting window.
ᕥ Floppy disk drive for saving and recalling measur-
ing conditions. It is also used to upgrade measure-
ment software by loading the upgrade software.
(Measurement software resides in internal memory;
the floppy disk drive is used when upgrading this
software.)
ᕦ Connector for input of data and clock for error rate
measurements. (BNC connectors on the rear panel
are also for data and clock input.)
ᕧ Audio analyzer and AF Oscillator I/O Connector are
used to evaluate FM radio equipment and AF cir-
cuits.
ᕨ Auxiliary I/O connector for obtaining signal genera-
tor output at higher levels than provided by MAIN
connector, or for analyzing low-level signals (No
function is provided for calibration of absolute
power measurements.)
ᕩ Connector for antenna output of radio equipment
for reception/transmission tests. It can also serve
as input to the power meter.
ᕥ