Atec Agilent-E4443A-45A-40A-47A-46A-48A - Manual (Page 20)

20
Rear panel (continued)
Monitor output
Connector VGA compatible, 15-pin mini D-SUB
Format VGA (31.5 kHz horizontal, 60 Hz vertical sync rates, non-interlaced) Analog RGB
Resolution 640 X 480
Noise source drive output (used by Option 219)
Connector BNC female
Output voltage On 28.0 ± 0.1 V (60 mA maximum)
Off < 1 V
Remote programming
GPIB interface Connector IEEE-488 bus connector
GPIB codes SH1, AH1, T6, SR1, RL1, PP0, DC1, C1, C2, C3, and C28, DT1, L4, C0
Serial interface connector 9-pin D-SUB male (factory use only)
LAN TCP/IP interface RJ45 Ethertwist
USB interface (Option 111, standard) Slave mode/device-side only, USB 2.0 compliant, type B connector
Parallel printer interface connector 25-pin D-SUB female
321.4 MHz IF output 1
Connector SMA female, 50 Ω nominal
Frequency 321.4 MHz nominal
Conversion gain
Low band (3 Hz to 3.05 GHz) • +2 to +4 dB nominal
High/mm band (2.85 GHz to
PSA’s upper frequency limit) • –6 to –8 dB nominal
High/mm band (2.85 GHz to
PSA’s upper frequency limit);
preselector off (Opt 123) • –9 to –17 dB nominal
Bandwidth (-3 dBm)
Low band (3 Hz to 3.05 GHz) • 40 MHz or 60 MHz 2 nominal
High band (2.85 to 26.5 GHz) • 35 to 70 MHz 3 nominal
mm band (26.5 to 50 GHz) • 40 MHz or 60 MHz 2 nominal
High/mm band (2.85 GHz to
PSA’s upper frequency limit);
preselector off (Option 123) • 240 MHz nominal
Pre-sel tune output
Connector BNC female
1. Not available for the E4447A.
2. 40 MHz standard, 60 MHz with Option 122 or 140 installed in instrument. When Option 122 or 140 is installed, the IF output signal
is now centered at 300 MHz and the BW of the output centered at 300 MHz is approximately 95 MHz.
3. The bandwidth in the microwave preselected bands increases approximately monotonically between the lowest and highest tuned
frequencies. Refer to the PSA Specifi cations Guide (E4440-90606) for more details.
Inputs and Outputs
(continued)