Atec Kepco-KLN Series - Manual (Page 6)

KLN INPUT SPECIFICATIONS
SPECIFICATION RATING/DESCRIPTION
Input Voltage 750 & 1500 Watt 100-240Vac, 50/60Hz
3000 Watt 190-240Vac, 50/60Hz
Input Current (Full load) 750 Watt 8.1A@115V a-c; 4.1A@230V a-c
1500 Watt 16.2A@115V a-c; 8.1A@230V a-c
3000 Watt 15.6A@230V a-c
Inrush Current 750 Watt 12.5A@230V a-c
1500 Watt 25A@230V a-c
3000 Watt 50A@230V a-c
Power Factor (PF) 750 & 1500 Watt 0.99 (at 115V a-c, rated output)
Typical
3000 Watt 0.99 (at 230V a-c, rated output)
Efficiency 750 Watt 76% - 87%
1500 Watt 77% - 88%
3000 Watt 82% - 88%
Isolation Voltage Input-Outputs 2000V a-c: 1 minute
Input-Ground 2000V a-c: 1 minute
Output-Ground 350V d-c, leakage current: 100µA
(6V-150V)
Output-Ground 1200V d-c, leakage current: 100µA
(300V-600V)
KLN OUTPUT SPECIFICATIONS
SPECIFICATION RATING/DESCRIPTION
Type of Stabilizer Constant Voltage (CV)/Constant
Current (CC), automatic crossover
Adjustment Range Voltage 0 to 100% of rated voltage
Current 0 to 100% of rated current
Protective Functions Programmable overvoltage (OVP)
Programmable overcurrent (OCP)
Overtemperature (OTP)
Fuse blown
Protection Setting Overvoltage 0% to 110% of rated voltage
Range
Overcurrent 0% to 110% of rated current
Remote Error Sense Compensation 5V max. (See Applicable Model Table)
Parallel Operation Up to 5 units maximum,
automatic load sharing
Series Operation 2 units maximum
(total voltage must not exceed 600V)
Temperature, Constant Voltage Mode 100ppm/°C of rated output voltage
Coefficient Constant Current Mode or current, after 30 minute warm-up
Time Drift Constant Voltage Mode 0.05% of rated output voltage
Constant Current Mode or current over 8 hrs interval following
30 minutes warm-up.
Constant line, load and temperature.
Transient Constant Voltage Mode 20V and under: ≤1.5ms;
30V-100V: ≤1ms
150V-600V: ≤2ms
KEPCO, INC. • 131-38 Sanford Avenue • Flushing, NY 11355 USA • Tel: (718) 461-7000 • Fax: (718) 767-1102
Email: [email protected] • www.kepcopower.com 6
Parallel connection of two identical KLN power supplies
(up to five possible) using optional Parallel Socket Board 536-0129
and Programming Port Cable 518-0119
Series connection of two identical KLN power supplies
using optional Series Socket Board 536-0130
and Programming Port Cable 518-0119