Neff K5764X0 - Manual (Page 27)

27
Fault Remedial action Possible cause
Refrigerator has no
cooling capacity. Appliance has been
switched off. Press the on/off button Fig. 2/1.
Power failure; the fuse has
been switched off; the
mains plug has not been
inserted properly. Check whether the power is on, check the
fuses.
The temperature in
the coolĆfresh"
compartment is too
cold or too warm. The fixed setting has been
selected too high or too
low. The temperature in the coolĆfresh"
compartment can be corrected (for example,
if there is frost in the coolĆfresh"
compartment).
For this purpose, switch off the On/Off
button, Fig. 2/1. Simultaneously press
buttons Fig. 2/2 and Fig. 2/1 until display
Fig. 2/4 flashes.
Then the set temperature flashes (e.g. 4 °C).
To set the temperature, keep pressing the
button, Fig. 2/2, until the required
temperature is displayed.
Step 0 - coldest setting
Step 6 - warmest setting
Step 4 ć factory setting (almost 0 °C)
The numbers on the display do not
correspond to °C temperatures in the
coolĆfresh" compartment.
The set temperature is saved after 1 minute
and the display switches back to the current
temperature in the refrigerator
compartment.
Attention: If the display, Fig. 2/4, does not
flash, the buttons were inadvertently held
down too long. Switch off the appliance
again and repeat the process as described
above.
en