Atec Keithley-2290-10 - Manual (Page 3)

Model 2290-10 High Voltage Power Supply Characteristics
Specifications are subject to change without notice.
SPEC-2290-10 Rev. A / December 2013
Page 3 of 3
GENERAL:
Input power: 75 watts
2290-10 Input voltage: 90 V – 246 V AC, 47 to 63 Hz
Rear panel connectors:
Output high-voltage connector: SHV-style male (Kings type 1764-1 or equivalent)
BNC Connector (Three): Input, Voltage monitor; Current monitor
GPIB connector, 23-pin
RS-232, 9-pin D-sub
High-voltage safety interlock:
Connector: 3-pin press-in connector, 3M part number: 37103-A165-00E-MB
Pin 1: 5 V nominal out, 70 mA maximum out
Pin 2: Input: High-voltage output enabled: >2.8 V to 5 V DC
High-voltage output disabled: <1 V DC or open connection
Pin 3: Chassis ground
Interface protocol: IEEE-488.1
Operating environment: 0º C to 40º C; non-condensing
Dimensions: 89 mm high x 206 mm wide x 356 mm deep (3.5 in x 8.1 in x 14 in)
Weight: 3.7 kg (8 pounds)
Safety: Conformance to European Union low voltage directive
Warranty: One year
Warm-up time: One hour