Autel MaxiCheck EPB - Manual (Page 121)

119
NOTE: The data you input must be in the reasonable range. If
the input data is out of range, the tool will display a warning
message “Permissible adjustment range exceeded.”
B. Reset adjustment to 100%
From the Injection rate menu (Figure 11.16) use the LEFT/RIGHT
scroll button to select 【2】and press the OK button. The tool will
automatically reset the value to 100%.
C. Store data and exit
When you have finished the injection volume adjustment, use the
LEFT/RIGHT scroll button to select 【3】 and press the OK button
to store the new value in the control units; or, select 【4】 and press
the OK button to retain the old value.
11.3.3 Injector rate adjustment
This function enables you to adjust the injector rate for individual
cylinders.
1) From the service functions menu (Figure 11.11) use the
UP/DOWN scroll button to select Injector rate adjustment
and press the OK button.
2) The tool communicates with the vehicle and reads the fault
codes memory. Follow the on-screen instructions to finish this
procedure.
3) Then the tool will display as below. In this function, you can
enter new value for each cylinder.