Baldwin Soho AC Z-Wave Deadbolt - Manual (Page 4)

4
a. Making sure wires are clear of pinching and wire harness is routed as
shown, place the interior assembly on door, aligning torque blade inside
the turnpiece shaft.
5. Continued.......
6. Install Interior Assembly.
Note: Turnpiece may be difficult to turn until step 8 “Automatic - Bolt
Direction Determination” is completed.
Route wires down - avoiding any
excess bulge at curve, which could
interfere with battery pack installation.
b. Once flush on door, insert and tighten small screws to secure assembly onto
the mounting plate.
Note: To aid insertion of screws, approach the screw holes with the screw loaded
onto the screwdriver.
c. Once aligned, push the connector in firmly to connect.
b. For easier orientation, view the alignment of connection from the top of
the interior assembly.
Wire Harness
Torque Blade
Small
Screws
Turnpiece
Shaft