Bird B Gone Bird Jolt Flat Track - Manual (Page 5)

Inc.
®
R
(800) 392-6915
5
Bird Jolt Flat Track™
Snug Fit Connectors:
Often Snug Fit Connectors (BJFT-SFC-10) need to be attached to connect two pieces of Flat Track.
Be sure to cut the end of the track as straight as possible for maximum effectiveness.
® Attach the Snug Fit Connector base to the end of the
track, allowing the track to reach the center of the
connector.
® Take the second piece of track, cut it straight and insert
it from the other side of the connector so that the
two pieces of track meet in the center of the Snug Fit
Connector.
® Snap the top of the Snug Fit Connector in place (apply
pressure to ensure full contact with pins and track) and
apply a dollop of glue on the outside to seal.
® Be sure to glue the Snug Fit Connector down to the
surface and then continue to glue down the track.
Snug-Fit Connector
T-Connections:
Occasionally you will need to install the track in a “T-style” connection. It is best to use Snug Fit
Connectors to create a simple connection.
® Insert a Snug Fit Connector on the track where you
expect the “T” to terminate. As the track approaches
the Snug Fit Connector to create the “T”, you will need
another Snug Fit Connector at the end of the track.
® Cut a 3”- 4” section of track and attach it to one end of
the Snug Fit Connector as described above.
® Attach this to the end of the track terminating in the “T.”
® Use lead-in wire (BJFT-LIW) to connect the two Snug
Fit Connectors. This is done by stripping the ends of the
lead in wire and attaching Blue Wire Connectors (BJFT-
BCN100) to each of the four ends of the wire.
® Push each connector over the tabs on the Snug Fit
Connector and crimp to secure. Snug-Fit Connector T-Connection
Step 6: Adding Connectors