Bird B Gone Bird Jolt Flat Track - Manual (Page 7)

Inc.
®
R
(800) 392-6915
7
Bird Jolt Flat Track™
Step 7: Attaching the Flat Track to the Charger
The most common and safest way to connect the Bird Jolt Flat Track to the charger is
to use a Snug Fit Connector to create a connection.
® Attach Connector Loops (STPWC-10) to one end of the lead wire, while connecting
Blue Wire Connectors to the other end of the lead wire.
® Cut a 3”- 4” section of track and attach into one end of a Snug Fit Connector. Attach
this connector to the end of the track that will be connected to the charger.
® Place the Blue Wire Connectors over the tabs on the Snug Fit Connector and crimp
to secure.
® Test the charging unit using the Voltage Tester (BJFT-VLT) to make sure it is working
properly. Optimally the charger should max out at: Solar Charger - 7.0 KV Electric
Charger - 750 V.
® Once you have determined the charger is working, attach Connector Loops to the
charger’s knobs and use wingnuts (included) to secure the loops.
® Test the track using the voltage tester several times at different locations on the
track, especially after every connection, to ensure the unit is functioning properly.
Do not use more than one charger (Solar or Direct) on the same run of the Flat Track.