Fan & temperature switch, Sata or sas hdd access led signal auto selection – Chenbro SK33502 Installation Guide with 3Gb/s SATA/SAS Backplane - Manual User Manual

Page 13

Advertising
background image

13

SK33502 ver. B0
User’s Manual

www

.chenbr

o.com

15Fl., No.150, Jian Yi Road, Chung Ho City, Taipei Hsien, Taiwan R.O.C.,

Tel: +886 2 82265500 Fax: +886 2 82265392 Email: [email protected]

SW1 Default Setting

Setting for SATA-I HDD (RAID Card)

Connect the 5-pin HDD LED cable to the CATHODE of the HDD activity pin header on RAID card. Refer to

your RAID card’s user manual for the detailed pin definition.

Fan & Temperature Switch

DIP 1:Fan Enable / Disable

1

Fan Enable / Disable

ON Enable

OFF Disable

DIP 2:Threshold Temperature Setting


SATA or SAS HDD access LED signal auto selection

This Jumper (CN8) is located behind the rear fan cover. Refer to page 16 for cover removal.

Jumper Closed: Enable auto selection

Jumper Opened: Disable auto selection. HDD access LED setting for SATA HDD only.

2

Threshold Temperature

ON

65

OFF

55

Default setting

Advertising