I-View SDCI-220 Indoor Speed dome - Manual (Page 14)

14
1. Carefully read the operation manual and the points for attention.
2. Carefully set the communication code, baud rate and address of the
dome camera and make confirmation they are correct.
3. Take out the plug of the dome camera and connect external power
supply, RS485 and video wires as per marks on the plug. Take care that the
power supply of the dome camera is DC12V/1.2A and adopt the particular
power supply, which comes with the camera.
Take out the mounting base from the spherical camera; thread the
connecting wire from behind through the central hole of the base. Fix the
base by three screws on the ceiling as per the drawing, and connect the wire
with the ball. Aim the latch in the ball with the notch on the base as per the
drawing, and mount the ball upward to the position and turn it clockwise
until the spring sheet on the base takes effect. In case the wire could not
come out from behind the ceiling, please open a hole on the edge of the
casing for the wiring.