I-View EC-2MIPN 2-Megapixels Day/Night Box IP Camera - Manual (Page 13)

5. Camera Fix Screw: Used when the adjust focus of Lens already.
6. Light Sensor: Detect the light to enable /disable IR Cut; the setting mode must be “Active
“ mode.
7. Power Port: Used to plug the DC 12V power adapter when no use PoE Hub.
8. Network Port: Used to connect a PoE or LAN cable. Power indicator (Orange LED) will be on
when connect with the PoE Hub; the Orange LED will be flash when plug the communication is
available.
9. Terminal Block: See the pin define as below:
 Video Out: Video analog signal output port connected to the monitor.
 Audio out: The terminal block is connected the speaker to output voice.
 Audio in: The terminal block is connected the microphone for audio signal input.
 Ground: Common port where the Video out /Audio in & Audio out signal is connected.
 Alarm in: Digital input; Accept dry contact signal only.
 Alarm out: Digital output; Connects to external peripherals by wire.
 Sensor in: Used to connect the external light sensor to detect the light to enable /disable IR
Cut; the setting mode must be “Passive “ mode when used the external light sensor.
 Ground: Common port where the alarm in and alarm out signal is connected.
 Ground: Common port of DC12V.
 DC12V out: Provide DC 12V power source the other device application such as microphone.
13