I-View EC-5MIPN 5-Megapixels Day/Night Box IP Camera - Manual (Page 20)

20
7.
Network Port: Used to connect a PoE or LAN cable. Power indicator (Green LED) will be on
when connect with the PoE Hub; the Orange LED will be flash when plug the communication is
available.
8.
Audio Out: The terminal block is connected the speaker to output voice.
9.
Audio In: The terminal block is connected the microphone for audio signal input.
10.
Rest: Press and release the recessed reset button with a straightened paper clip.
11.
Micro SD Slot: Inserts SD card for video/snapshot recording. Max.64GB SDHD card supported.
12.
Antenna: For WI-Fi Antenna adapter (Revised).
13.
Power Indicator: The LED will be on when plug the DC 12V power adapter or POE Hub.
14.
USB Port: Used to Wi-Fi adapter (Revised).
15.
Terminal Block: See the pin define as below:
Alarm Out: Digital output (1A/1B); Connects to external peripherals by wire
Alarm In: Digital input; Accept dry contact signal only.
Ground: Common port where the alarm in signal is connected.
RS-485 (-)/ (+) : RS-485 control port for the Pan/Tilt motor . The protocol supports Pelco P
and Pelco D.
16.
BNC Port: Composite Video output.
17.
Power Port: Used to plug the DC 12V power adapter when no use PoE Hub.