MoTeC BR2 BTX - Manual (Page 40)

38 Appendices
Appendix F – BR2 Configuration Loom
If the BR2 is not connected to the vehicle CAN Bus, then a standalone wiring
loom is required to configure the BR2.
The wiring loom below provides power to the BR2 and to the MoTeC CAN
Cable and allows the CAN Cable to communicate with the BR2.
1
Ground
BR2
0V
CAN Cable
Connector
1
2
SwOut
2
3
Power 8V
3
4
CAN-LO CAN-LO
4
5
CAN-HI CAN-HI
5
-
DC Power
6.5 to 12V +
Connect
MoTeC
CAN Cable
here
BR2 Mating Connector
Deutsch AS606-05SN-HE or ASL606-05SN-HE