C.E. Niehoff & Co. C619/C630/N1222/N1223/A1-607/A1-608 Troubleshooting Guides User Manual
Page 4
Advertising
Page 4
TG8B
Section C: Advanced Troubleshooting
Yes
No
For “no voltage output” condition:
• with
energize switch, go to Chart 2, page 5.
•
with
ignition switch, go to Chart 3, page 6.
Is there a battery isolator in the system?
Chart 1 – System Circuit
Install temporary jumper between one battery terminal and alternator
terminal on isolator. Use minimum 12 AWG wire.
Do not operate charging system more than two
minutes with jumper installed. Charging system volt-
age will be abnormally high and damage other components.
START HERE
CAUTION
Advertising