Carolina C2616 FOUR-STUDENT WORKSTATION - Manual (Page 6)

5. Screw the leveler to the leg and attach leg boot.
6. Line up the holes in the wing and the leg and insert 4-1/2” x 5/16” carriage bolt and tighten washer
and nut. Leg should be perpendicular to the wing. Use leveler on leg to level the wing with the
cabinet.
Figure 6A
Figure 6B
7. Repeat wing and leg instructions on the other side of the cabinet.
8. Do not apply pressure to the wings at this time. They are not strong enough to withstand weight
until the top is attached.
9. (If Applicable) Assemble the Rod Socket Assembly as shown in Figure 9A.
(If Applicable) Attach Rod Sockets to Top as shown in Figure 9B.
Figure 9A