Carolina C2616 FOUR-STUDENT WORKSTATION User Manual
Page 8
Advertising
13. Put a bead of silicone seal along the sink cutout on the top. Lower sink in place. Remove any excess
caulk that is displaced around the sink.
14. Cut the rubber base molding and attach using contact cement. After molding is in place, use the #6 x
½” SS screws to attach the stainless steel corner brackets on each corner over the base molding.
15. All water, electrical and gas connections should be performed by a trained professional.
(Note: When multiple units are assembled together apply silicone to the edge of the tops that are
being joined against each other. Remove any excess silicone. Allow 6-12 hours to cure.)
16. Reverse pulls to the exterior of unit as shown.
Advertising