Castle TSM-11 - Manual (Page 13)

CASTLE, INC TSM‐11 OWNERS MANUAL V1.4 Page 13 of 22
5. Push the black handle away from operator rapidly until
it hits the stop. This routs the pocket. If you release
the black handle, the machine will move to the neutral
position on its own. It is not necessary to release the
black knob before proceeding to step 6.
Note: The first pocket you cut will create a through slot in the worktop. To insure a
clean cut, make sure a work piece is securely clamped in place.
6. Pull black handle toward you rapidly until it hits
the stop. This drills the pilot hole.
7. Release the black handle. The operating lever
returns to the neutral position by itself.
8. Pull the clamp lever (red handle) toward you to
release the material clamp.
9. For additional pockets repeat steps 2 through 8.
Fig 19
Fig 20
Fig 21
Fig 22