Adjusting the depth of the head – Castle LB-23 Operator Manual User Manual

Page 15

Advertising
background image

Inside machine view


ƒ Using a 9/16" wrench, LOOSEN the nuts while someone else holds the

wing table in the desired position.

ƒ Once the proper position has been achieved, tighten down the nuts.

ƒ Repeat for the other side.

Adjusting the depth of the head


The travel limiter controls how far down the head can move towards the tabletop
and into the stock. If your holes are not deep enough or they are too deep you
may need to make an adjustment to the Travel Limiter bolt.

ƒ Locate the 1/2" hole just left of center in the bit cover on the top of the

machine. You'll know you have the right hole because when you look in
it there will be a large Philips head screw inside.

13

Advertising